MVT
Ignition digital direct + light derbi euro 4
246,00 €prima 328,00 €−25%
Prezzo verificato il 21 novembre 2026.
In breve
- Marca
- MVT
- Venditore
- Scooter Attack
- Condizione
- Nuovo
- Disponibilità
- Disponibile
Dettagli prodotto
Digital Direct internal rotor ignition with light MVT Digital Direct 28 internal rotor ignition with light coil for Derbi Euro 3 / Derbi Euro 4 with balance shaft. Why pick the MVT Digital Direct? The MVT Digital Direct is a digital internal rotor ignition.
The ignition timing varies depending on engine speed to achieve maximum power. Ignition timing controlled by a CDI unit (included). Recommended for racing and high-end setups 70cc and above.
A special feature of the MVT DD is the 12 Volt – 55 Watt connection for light (or electric water pump). You can replace your original ignition with this performance enhancing internal rotor ignition and still power all the on-board electronics / vehicle lighting. The lightweight inner rotor makes the engine much more agile and produces more power over a wider rpm range.
How to set up an MVT DD ignition? First remove the original ignition and install the MVT Digital Direct ignition correctly. Do not tighten screws on the stator and rotor until the ignition is set up and adjusted properly.
It is best to use a micrometer / ignition dial gauge and follow the guidelines: 0.4 mm before OMT for original stroke and 0.35 mm for long stroke. Then connect the ignition to the wiring harness (see instructions). For even more power, we recommend the use of an MVT Eprom module with pre-programmed ignition curves.
We also recommend the use of a racing spark plug. required tools Micrometer for adjusting ignition timing. Suitable for: Derbi Euro 3 and Derbi Euro 4 WITH balancer shaft If you want the ignition for Derbi without balancer shaft: MVT-DD11